Another HERMS...

[punchy21]

Gday guys, i just thought id post a few pics of a HERMS set up i have been working on. It is another build inspired by Hill, Mac, Bushy, Kimbo and anyone else who has built one pretty much... :clap:

My HERMS container is just a piece of 4" offcut i had spare, with a half inch coil approx. 5-6m.

IMG_1304.JPG

The pump is a keg king "march" style high temp pump.

IMG_1305.JPG

The tun is just a keggle with the top cut out and a few valves.

IMG_1306.JPG

And the controller uses a Sestos PID.

IMG_1307.JPG

The DIY element adapter with a moulded socket.

IMG_1302.JPG

[punchy21]

And here she is doing a cleaning run.

IMG_1303.JPG

[Andy]

looks great punchy!
where did u got that socket from?

[1 2many]

Very nice punchy how does she run?

Andy you can get those sockets from old pc power supplies. :handgestures-thumbupleft:

[Hill]

Looks awesome mate :handgestures-thumbupleft:

[MacStill]

Looks pretty flash punchy, top job on the coil too :handgestures-thumbupleft:

What size did you use to wrap the coil around ? that's pretty tight for for 1/2" to fit 4" pipe :clap:

[punchy21]

Cheers guys...

It ran up pretty good until it overshot my set point of 66 by about a degree and a half and stayed there. After a quick change of the settings it started auto tuning and came back to set point after tuning and pretty much stayed there.

This is where i got the socket/inlet from http://www.ebay.com.au/itm/281158075359 ... 1497.l2649

Yeah Mac I went to grab some 6" from Parkwood's but they wouldnt sell me a half metre length so I made do with what i had, the 1/2" flattened out a bit but she is a snug fit - for the coil i used a wine bottle wrapped in a layer of gaffa tape in case it broke :? , the pliers came in handy to open the flatened pipe up a bit so it looks a bit rough...

[bayshine]

Fantastic setup mate :clap: :clap: :handgestures-thumbupleft:

[Andy]

glad it ran well :handgestures-thumbupleft: and thanks for the link :)

[1 2many]

Where are you getting the 3 way valve. and is it 1/2 inch. :handgestures-thumbupleft:

[punchy21]

You can get em off ebay from china or this was surplus to our stock at work - with the right approvals of course :handgestures-thumbupleft:

[RuddyCrazy]

G'day Punchy,
Great idea for a HERMS and last night (after a chat in the pub on the weekend) I picked up a free keg so I am thinking well a HERMS has to be the go for me.

Now when I was making that reflux before I joined this forum I got some 1/2" rolled to fit inside some 3" SS. Now all I used was a spring based copper bender and a 32mm pipe for the former. It was hard going but I got there. Now off memory at that scrap yard I did see a heap of 3/8" copper pipe so some of that will on my list this week.

Cheers Bryan

[punchy21]

G'day Bryan, if I were to do it again I would go a bigger HERMS container or a smaller tube for the coil, like the 3/8 you mentioned...