pipe surface area calculator for shotty

[bluc]

Can anyone point me at a calculator to work out surface area for pipes when making a shotty I want to work it out so I can have max cooling as my pc shotty will be short as possible prob 300-350mm cheers

[Flowerpot]

Google. Seriously. Search for "surface area of a cylinder" its pretty simple anyway. Pi * diameter * height

[bluc]

Ok ta

[Doubleuj]

Why do you have to go so short on a PC?

[bluc]

Headroom/ collection height..macs are 400 i figure if i do 6- .5" pipes i can shave 50mm off..

[Zak Griffin]

Your shotty doesn't have to be vertical ;-)

[bluc]

But i want it vertical..

[Zak Griffin]

Just tossing ideas out there mate.

What about going to a 2.5" or 3" shell for the PC?

Or try a 2" x 350mm, it's a lot of work and copper down the drain if it doesn't work though :think:

What cooling setup have you got?

[bluc]

To fit it in a cupboard..i may just have to be happy with 400 and a long connection to collect on the ground, if you guys reakon 350mm is to short.6x 1/2 inch at 350mm has slightly more surface area then 4 x 3/4 @ 400. Is it just cooling the output because i reakon it will knock down 2400w..

[bluc]

Just tossing ideas out there mate.

What about going to a 2.5" or 3" shell for the PC?

Or try a 2" x 350mm, it's a lot of work and copper down the drain if it doesn't work though :think:

What cooling setup have you got?

Yep and i appreciate the help, currently have 200l drum and evap aircon cooling the water, plan to also add a split system condenser..but will go ibc if needed. Shotty will be for a 4" pot that will end up a bubbler.. :-B

[coffe addict]

Hey bluc, with using an evaporative air con to cool you might want to go a bit longer on the pc as it'll mean that you can have a lower flow rate of coolant. This should help with the evaporative aircon as a slower flow rate will give a longer period getting cooled.