kimbo wrote:I would probably just weld the reflux line direct into the reducer above your take off- its up to you :handgestures-thumbupleft:
Mine is a double reducer design ;-)
McStill wrote:I gotta say there is a lot of more simple designs out there that will perform as good as the ones above, being a first build dont over complicate things, you will eventually build another anyway :laughing-rolling:
kimbo wrote:I made mine 950mm and still works a treat ;-)
sam wrote:McStill,
Could this design be adapted to be a 3"? if so, how high should the cloumn be? and what size should the reduced section be?
also, please explain how the "cup" is supported?
Cheers
sam wrote:
If it's built as a 3" diameter column,, the reduced section pipe diameter should be ???
Cheers
McStill wrote:2"
Users browsing this forum: No registered users and 94 guests