Aussiedistiller, Home Distilling, Moonshine, Home Brew

So thought it was about bloody time I started building this new new gear I keep saying I'm going to, working with what I have around the place to start with I've made a start on the parrot.

Just wondering if the reducer I'm using for the overflow on the parrot will be too small?





The reducer is only just sitting in place by friction at the moment, just unsure if I should try and get a larger diameter one instead?

It will may work, but if you anneal it then use a solid screw driver and roll it around the larger diameter end you can flare it so that it will defiantly work, (obviously before you solder it together)
:handgestures-thumbupleft:

Hadn't thought about flaring it out! Cheers! Not quite able to picture how to use a screwdriver to do it, but surely I can find something around here that will do the job :handgestures-thumbupleft: