Alternative Fill Port Ideas
Posted: Fri Jul 02, 2021 1:33 pm
I want a fill port on my boiler, but don't want to actually go through the process of fitting one.
Here is what i'm thinking of adding instead.
Let me know what you think (pro's - con's) or if there is some easier way that i just haven't thought of or seen yet.
Cheers Off'y.
i already have a 4" fitting on my boiler so i was thinking:
This would probably add the least height to by setup. i would have to check that it clears the chime or cut some of the chime away which is not really an issue.
or
The Y type spliter might be cheaper but taller? however not as readily available in Aus i believe?
There are similar 2" ones of the Y spliter that have a 4" strainer in/on them. i have no idea on cost or availability of these ones either.
Here is what i'm thinking of adding instead.
Let me know what you think (pro's - con's) or if there is some easier way that i just haven't thought of or seen yet.
Cheers Off'y.
i already have a 4" fitting on my boiler so i was thinking:
This would probably add the least height to by setup. i would have to check that it clears the chime or cut some of the chime away which is not really an issue.
or
The Y type spliter might be cheaper but taller? however not as readily available in Aus i believe?
There are similar 2" ones of the Y spliter that have a 4" strainer in/on them. i have no idea on cost or availability of these ones either.