Advice on Leibig build.
Posted: Mon Jun 12, 2017 8:50 pm
Hi again,
Hope this is the right location for this question, but will it help when building a Liebig condenser to solder baffles inside the water jacket to create turbulence in the coolant or is it a waste of time? The condenser is 700mm long, 12mm copper tube with 25mm outer tube.
It will either be run directly off a gas heated 50l keg pot with 2in column, or after a 19l thumper keg.
Your thoughts are appreciated.
Cheers
Hope this is the right location for this question, but will it help when building a Liebig condenser to solder baffles inside the water jacket to create turbulence in the coolant or is it a waste of time? The condenser is 700mm long, 12mm copper tube with 25mm outer tube.
It will either be run directly off a gas heated 50l keg pot with 2in column, or after a 19l thumper keg.
Your thoughts are appreciated.
Cheers