bt1 wrote:that's a hell of a lot of hassle with a thumper to get the marginal improvement in output...20 years ago ...sure...now far better options.
A hybrid pot,
bt1
McStill wrote:bt1 wrote:that's a hell of a lot of hassle with a thumper to get the marginal improvement in output...20 years ago ...sure...now far better options.
A hybrid pot,
bt1
Is this the type of thing you mean ?
:teasing-neener:
Galah wrote:Thanks for your advice mate. However, I have propane, not butane.
In any case, it doesn't seem up for the job. It did for about 1 minute, and I wish I knew what I did to get it flowing, but that was it.
I hope the yellow one fits onto my torch fitting. I don't want to have to buy a whole new torch setup.
crow wrote:ok the Bunnings guy said I could use the same torch is that not so?
bt1 wrote:geez mac
that's a nice piece of kit but more to the point it's a great concept...
see any value in a CM external 8 - 10 wind cooling arty deco looking 1/4" coil pre reduction to 2" perhaps? Possibly pre product condenser cooling feed?
Reason I mention is my early hybrids use either a cold finger or double helix coil to get the abv's I'm happy with for a single run bourbon clone. Or if your on the mark for abv's why fuck about I guess.
bt1
Galah wrote:Thanks guys. What's smearing?
Users browsing this forum: No registered users and 10 guests