RC Al wrote:How hot is the exit water of your condenser?
If its cold, slowing the rate down may help you
If its ouchies hot, you might need more water flow
Adding scrubbers to your coil may help too, but yours looks very tightly wound - how much clearance dose it have on the sides?
How far below the take off dose the coil extend? You haven't left much room for adjustment if it stops around the ferrule. Consider chopping 2" off the top and adding it as an extension spool under the head to give you more control.
There's no issue with the condenser water. Still comes out cold. It's just as you said, if I life the coil up it doesn't give alot of knock down room before the goodies sneak out into the atmosphere.
I could always chuck something like a 2" sleeve over the top to extend it a little but then it won't go low enough to block off the PC hole.
I'll figure it out though. I have time... Just not the skills. Still struggling with my soldering.