hillzabilly wrote:Lookin good mate ,I would use a 2inch copper cap with a few small holes(in the same patern as the coolant tubes) and a small piece of copper mesh underneath on top of the shotty,or lightly pack the last couple of inch's of the coolant tubes with copper mesh,it makes it more efficient and reduces huffing or the chance that vapour will only pass thru a couple of the coolant tubes,wich may happen if the vapour is comeing from one side (as with the boka or slant plate desighn)and not going into the shotty evenly or has a high speed,some mesh underneth the shotty may help as well ,another benefit is it will keep shit bugs or dirt from getting in while running or in storage .anyhooo cheers hillzabilly :handgestures-thumbupleft:
Damn, great minds thinking alike. I had just come inside after stuffing a little mesh in there and saw your post. :handgestures-thumbupleft: I will be putting a cap on of some sort too, mainly so I can mount a thermometer with an over-temperature alarm up there, but keeping crap out will be a bonus.
I've got a heap of heads and tails will that do for a final cleaning run?