by Kenster » Tue May 23, 2017 8:34 pm
Skara, keep up the good work mate... my 2c.. i realise you have gone off the idea of 'getting' a TIG yourself, went down that path also, GAS is insanely expensive and given that (we) would be novices, a LOT of wasted gas... not good & good call.. Secondly, suss out the 'cup type' Boka as opposed to the slant plate, you could incorporate copper internals which may help a bit with sulphides but straight off the shelf to make up and IMHO a better alignment internally. Finally, lots of lost time to heatup with the 2400w, if you swap up to 3600, add a simple voltage controller, you have all bases covered.