Cross Flow Shottie for Boka

[twojaythomo]

Hey all just out of interest whats everyones thoughts on a cross flow shottie for my boka/VM build, was trying to save on height it will be 2.5" X 440mm with 7 X 12.5mm tubes, it's gotta be more efficent then my other coil.

[Yummyrum]

If your existing coil can fully condense the maximum vapour from your boiler then it is probably efficient enough and you could re-use it in the hammerhead .

Another option is to slant the condenser maybe not so exagerated as below but get the idea .....coil not drawn for clarity

CCF01052014_00000.jpg

[twojaythomo]

I went to the scrap yard yesterday being 50 minutes drive I got enough spare copper I will not be going back so I have heaps for a shottie anyway, but if I can't get it to seal I will go with the coil.

Didn't even cross my mind to reuse the coil, shotgun condenser sounds better when I tell my mates anyway :D