by bt1 » Fri Dec 26, 2014 7:46 am
I'd raise a few minor concerns.
value for money = entry level abv rate unknown
Would need some copper packing = sulphides removal
Lid design, tacked supports = longevity
Inner diameter small= slow production rate
replaceable seals/ seal mtl is a silicon = good luck with making these as seat design is unknown
CM design = need accurate water control=valve/pump setup
thermo placement= meaningless info
lid seal is free form not seated = placement/sealing issues
Water valve size unknown= would need adapter to std. hosing
Spirit off take tube proximity to heat source = need a copper extension tube
Collection height once extension is added = limited space
Quality of SS mtl = unknown no certificates
Warranty = none
Spare = none
Customer feedback =none
Base adapter is sealed with thread tape = may need replacing
Apart from these few initial thoughts there may be other issues with hinge durability etc but that would require some closer inspection.
bt1