pulsetech wrote:
What about putting a Ball in the top of a Block Head ? Any potential issues with that ?
pulsetech wrote:Yes I did see it. I still don't get how that is going to clean the PC.
1 2many wrote:Is that a 1.5" to 2" joining ferule at the top Mac, Don't quite get how it all goes together. 8-}
1 2many wrote:Yeah that's how I figure it too, I just want to know if the ball goes through the 1.5"side reason is I want to use a temp dial indicator and that ferule is 1.5".
Oops to slow :oops:
MacStill wrote:1 2many wrote:Yeah that's how I figure it too, I just want to know if the ball goes through the 1.5"side reason is I want to use a temp dial indicator and that ferule is 1.5".
Oops to slow :oops:
For 4" stills I'll be attaching via 1.5" and having the smaller ferrule 3/4" :handgestures-thumbupleft:
6" rigs & boilers > 250L will attach as above pic
8" rigs & boilers over 250L will attach via 3"
pulsetech wrote:Great I didn't think it would get up and over the bend but given enough pressure I guess it would
1 2many wrote:Curios about the bearing setup as far as cleaning goes, how do you clean them I am just thinking they would clog up after a while. :-B
MacStill wrote:pulsetech wrote:Great I didn't think it would get up and over the bend but given enough pressure I guess it would
Yeah it sure would, have you seen the youtube vid I posted recently in this thread somewhere ?
I'm going to hook this up to the garden hose and get a couple of pics, just gotta set it all up and stay dry :-B :gay-umbrella:
1 2many wrote:How far down the track do you think the CIP kits will be, before there in the store.
MacStill wrote:1 2many wrote:How far down the track do you think the CIP kits will be, before there in the store.
I'm just about to order this week, so should only be about 3 to 5 weeks away at worst :handgestures-thumbupleft:
Users browsing this forum: No registered users and 77 guests