P3T3rPan wrote:Plumbers out there, am i wrong or right or are they actually 90 degrees???
ROFL
I think you are not seeing it
On a vertical pipe
91 degrees is over square (heading back up)
88 is under square (heading down)
The measurement is of the angle change from straight.
Not the enclosed angle
P3T3rPan wrote:The angle of change in direction is what matters. Not the enclosed angle
WTDist wrote:Na i haven't tried the wood bit for copper. I don't think the bits i have are that high in wood. Do they make them rounder?
I may have to re drill these out a bit as this bit is 12.5mm and my tubes are 12.7mm. Got this drill bit from my father in-law
WTDist wrote:Ok so ill sum up tonights efforts...
:angry-banghead:
:handgestures-thumbdown:
Resoldered and repulled it appart to start again. 3rd times the charm. basically was going well untill the heat made one end give way as i was about to solder the other in place. had to walk away before i smashed something :angry-steamingears:
Users browsing this forum: No registered users and 4 guests