wiifm wrote:
If there is one lesson that could be learned, it is NEVER leave your still unattended :))
jacobraven wrote:Ok this awesome build has inspired me after reading bt1 how to glasser I was sure I wanted bubble caps what is the overall diameter of the caps.
jacobraven wrote:Do you think the nuts would be secure enough on that much copper.
jacobraven wrote:Does make the machining a lot hard is there really that much need for disassembling
wiifm wrote:jacobraven wrote:Ok this awesome build has inspired me after reading bt1 how to glasser I was sure I wanted bubble caps what is the overall diameter of the caps.
Good question. I never measured.
http://www.5stardistilling.net/bubble-cap/
From memory, they require a 16mm hole. Hole spacing was 32mm I think.
If I had my time again, I'd have the mid plates cut like this:
Would require extra strength at each end, but would make for easier assembly / disassembly.
wiifm wrote:jacobraven wrote:Do you think the nuts would be secure enough on that much copper.
I am thinking no nuts for the mid plates.jacobraven wrote:Does make the machining a lot hard is there really that much need for disassembling
Up to you mate. It is your build after all. Someone else suggested these to me just the other day.
Linny wrote:Where do you find them! Or what are they called lol
Return to Plated Column Stills
Users browsing this forum: No registered users and 23 guests