by strongy12 » Thu Jan 14, 2016 10:28 pm
Its not quite finished i still have to insulate the column, solder on some hose connectors for the product cooler, solder in a brace for the product cooler and I want to cut it just below the slant plates so i can push the packing in and out easier. Oh and my voltage controller arrived the other day so have to wire that up.
The column is 1.5M packed section and im using copper mesh and stainless scrubbers. the coil is 1/4 double coil with cold finger. take off is 3/8. (i would never use 3/8 again cause the fittings are a prick to find an expensive) Element is a keg king one that i had for brewing beer.
Ive only ran it in pot mode last weekend after a vinegar run as i didnt have the product cooler finished and had a TPW that needed to come out of the fermenters.
Everything went well, no leaks, time to make some netural.
I just got a hold of 2 meters of 4inch pipe last weekend so the next build is a bubbler.