WTDist wrote:Hey tas good work there. I was wondering about one of these a while back. what do they look like inside? like a T500 boiler with a PID and few other bits?
edit, just googled it at the site.nice
TasSpirits wrote:WTDist wrote:Hey tas good work there. I was wondering about one of these a while back. what do they look like inside? like a T500 boiler with a PID and few other bits?
edit, just googled it at the site.nice
i was originally going to turn a T500 boiler into a mash tun, got the bits then decided against it, the Mrs got me this for my birthday(and so I dont mash in the kitchen anymore)
Nino wrote:TasSpirits wrote:WTDist wrote:Hey tas good work there. I was wondering about one of these a while back. what do they look like inside? like a T500 boiler with a PID and few other bits?
edit, just googled it at the site.nice
i was originally going to turn a T500 boiler into a mash tun, got the bits then decided against it, the Mrs got me this for my birthday(and so I dont mash in the kitchen anymore)
Hhhmmmmm, maybe I should start mashing in the kitchen :)
Tried that still apita to clean, design flaw as far as I am concerned :handgestures-thumbupleft:EziTasting wrote:Seeing as it has its own heating system, could you not just fill it up with water and (perhaps) some soap and set it on a sled-boil?!?!?
At least it would soften the 'goop' making it easier to clean out
scythe wrote:Can you not just cut the rolled edge off, would a can opener do the job?
Or make a replacement tube?
It is what i would do.
Users browsing this forum: No registered users and 39 guests