by MarkA » Thu Jun 23, 2022 6:02 pm
Hi NoHope,
I cut some 1/2" copper pipe and soldered them together with a 90* elbow. It's a bit heavy to just hang off
the spirit outlet, so a piece of 3/4" copper pipe was cut and notched to locate in the rim of the boiler, and
support the 1/2" pipe. An "O" ring keeps it in place. You could use anything for the support though.
I cut a piece of the supplied plastic hose just a little shorter than the outlet and pushed it on, then wrapped
ptfe tape around it until the 1/2" pipe was just a sliding fit. Making sure the whole thing angles down a little,
I haven't had any leaks, and it works like a charm.
Hope that helps.