Crusty wrote:Hey guys.
Just after some clarification on bubble plate installation using 4" sight glasses. Do the bubble cap plates sit inside the sight glass or should they be installed between the ferrules of the sight glass above it. The same as the sight glass tee's. Pictures of your sight glass still with plates installed would be awesome.
Cheers
BigRig wrote:Crusty wrote:Hey guys.
Just after some clarification on bubble plate installation using 4" sight glasses. Do the bubble cap plates sit inside the sight glass or should they be installed between the ferrules of the sight glass above it. The same as the sight glass tee's. Pictures of your sight glass still with plates installed would be awesome.
Cheers
Wellsy is your man.
I have the bubble tees and the plates sit inside the tees and are sealed tight by the gaskets.
TheRealMrMessy wrote:The Visualiser has plate-specific seals that fit in-between the glass tubes, in place of regular tri clamp seals. Probably same for your T pieces.
BigRig wrote:TheRealMrMessy wrote:The Visualiser has plate-specific seals that fit in-between the glass tubes, in place of regular tri clamp seals. Probably same for your T pieces.
That is so pretty and new. Get it dirty asap :handgestures-thumbupleft:
TheRealMrMessy wrote:The Visualiser has plate-specific seals that fit in-between the glass tubes, in place of regular tri clamp seals. Probably same for your T pieces.
Wellsy wrote:And here is a picture
Wellsy wrote:That would be a pain in the butt to setup. I had one of mine start to leak and trying to get the same tension on all nuts was time consuming to say the least
I sometimes just leave mine in full reflux all day just so 8 can watch it :laughing-rolling:
Wellsy wrote:My eyes are too cock eyed to read fine measurements so I went with an icy pole stick that was the correct length.
Mind you I had to eat 25 icy poles before I got the cut right lol
Users browsing this forum: No registered users and 19 guests