Im working on my new keg based pot still which is of the same basic design and shape as the one I built to fit my 25 litre boiler.
The main difference is that this one is built using 2 1/2 inch pipe. Im trying to use up bits and pieces of pipe and fittings I already have laying around the shed to build the condensers and am not sure that what I have in mind is gunna do the job of knocking down all the vapors especially on stripping runs
The plan is 2 1/2 inch reduced to a short section of 2 inch then a leigburg 10 inches long consisting of 1 and 1/4 outer tube and 1 inch inner tube which will then reduce into a 2 foot 4inch or 700 long lieburg consisting of 3/4 outer and 1/2 inch inner.
The keg will be sitting on a 3 ring burner
Suggestions or and ideas please.
SBB