So, bits and pieces together will be soldering on the weekend
what I have is
Column
a 40mm column (1.59 inch)
a packing height of 1150mm
an empty space of 60mm under the take off T
an empty space of two times pipe diameter above the take off T
a single wound 6mm tube reflux coil of about 300mm length/height (may do a cold finger set up yet)
Take off
40mm T
reducing coupling 40mm-22mm
an oversized (because I'm retarded) SS ball valve
reducing coupling 22mm-15mm
15mm elbow
Liebig
15mm x 1100mm inside 22mm x 1000mm
I made two of these, one for my pot still as well.
As usual my posts come with a question attached
If you look at the pic below you'll see that between the take off T and the elbow above the Liebig is a distance of 300 mm.
Is that distance a problem?
Cheers