Our New stir plate
Posted: Tue Mar 18, 2014 1:22 pm
So easy to make
Such fun to watch
A little food colour and some bran flakes to show the mixing
https://aussiedistiller.com.au/
P3T3rPan wrote:So easy to make
TheMechwarrior wrote:P3T3rPan wrote:So easy to make
Care to share some wisdom ;-)
P3T3rPan wrote:Some experimentation was needed for the spacing of the magnets. Try it before gluing the magnets to make sure the polarity is right or the stir bar will fly off centre.
P3T3rPan wrote:You can also use a potentiometer to control the speed apparently. I burned two up before finding I still had the multi volt purchased years ago. Start up on 12v, turn down to 9v for running. Should sound like a low hum. If it is tinkling it's probably too fast or out of balance somewhere.