P3T3rPan wrote:So easy to make
TheMechwarrior wrote:P3T3rPan wrote:So easy to make
Care to share some wisdom ;-)
P3T3rPan wrote:Some experimentation was needed for the spacing of the magnets. Try it before gluing the magnets to make sure the polarity is right or the stir bar will fly off centre.
P3T3rPan wrote:You can also use a potentiometer to control the speed apparently. I burned two up before finding I still had the multi volt purchased years ago. Start up on 12v, turn down to 9v for running. Should sound like a low hum. If it is tinkling it's probably too fast or out of balance somewhere.
Users browsing this forum: No registered users and 4 guests